ROADFAR Bumper Sensor, Reverse Backup Parking Assist Sensors Fit for Infiniti Q50 Q60 Q70 Q70L QX60 QX80 QX50, Altima Armada Maxima Pathfinder Titan/Titan XD Compatible 284383SH0B Sensor

Work perfectly on a 2016 Infiniti Qx50

Application: 2018 Nissan Armada PlatinumNOTE: Amazon's vehicle fit calculator says that these are NOT compatible with the 2018 Armada; however, my experience is that they are.One of the two front sonar sensors was acting up on our '18 Armada. I could tell by the monitor, which tells you in which zone the sensor is supposedly sensing 'something'. It had to be one of the front facing two, since it was always that zone that would alert when nothing was actually there.The dealership was peddling factory replacements for over $250/sensor; and that's not to mention the installation cost if I didn't want to swap them myself.You get at these from underneath the vehicle, so remove the engine plate (4 bolts) as you would with an oil change. In fact, I decided to do an oil change since I was already going through these steps.TIP: The clips that hold the sensors into the bumper mount actually SPREAD apart to release the sensor. Do not pinch the wings, as would be intuitive, as this will only hold the sensor in more resolutely.Appearance, fit and performance are very close/identical to stock, other than the color (.. they come white, but are typically painted by Nissan the same color as the vehicle ..)If I remember, I will update with longer term performance issues, if any.

Bought two sensors for my 2015 Q50 because my front bumper MOD sensors were firing in red as if there was something in front of my car.I picked these up although the prior reviews only indicated they were for backup sensors- after a few minutes of research, I was able to confirm that the rear and front sensors are the same. I plugged them in, fired up the camera and did a few tests and can confirm they work as expected.These came in a black color- so if your car is anything other than black, you may want to get them painted ( or if you’re a DIY, a rattle can spray down can do the job)

It came white which was awesome! I suspect it's maybe just primer, or something. It's not a perfect match, but it's close enough I don't care. Car no longer has the broken BCI error message, and it was cheap and easy to fix.

It worked for my QX80. I was not sure about the colour, thanks for answering my question for confirmation. I received also ‘white’ colour which is a match with my vehicle.Installation was super easy. You don’t need to go to a mechanic.It seems bit loose than original one. But it worked for me.It’s obviously a bang for the buck.

15 minutes and saved $950 for the 2 front middle sensors on a Q50.