bROK 12" Aluminum Ramp Kit for 2" x 12" Planks with Full Width scratchproof Pads. Create Universal Wood Plank ramps to Load and unload Lawn Tractors, ATVs, dolleys, and wheelbarrows

I ordered two of these kits to make a trailer ramp out of a 4 x 8 sheet of 3/4 inch plywood. It's probably over kill but since I was loading some pretty heavy stuff by myself, I was looking to reduce the stress on my body. It's a bit "spongy" so I'll put a couple of cinder blocks underneath about halfway up the ramp.

Good quality and cheaper than others

The ramp ends are just fine, very sturdy and well made. However, the packaging leaves a lot to be desired and is the reason for four stars rather than five. The cardboard box containing the contents is simply not heavy duty enough for the job. One end had ripped open and was repaired with tape at some point. The other end had then been ripped open as well but not repaired with tape. This resulted in me getting a set that was missing the mounting kit. Being to far and time consuming to return the package just to reorder another one, I had to go to the local hardware store to purchase the needed hardware required to mount the metal ramps to the wood. Obviously an inconvenience and added expense I shouldn’t have had to incur. Box them up better would be the simple solution.

Story, great color, nice sound.. she loved it

Does everything it is supposed to do. As for the individuals reviewing this product that say that the a standard board does not fit "in" the bracket. They are 100% correct. However, IT IS NOT SUPPOSED TO. It is designed to align with the edge of the board, not fit the board between. This provides the proper angle needed to be a ramp. Without it, the angle is too shallow. It provides no more stability to cut the board away and squeeze the 2 x 12 in there, and it ruins the angle.

Just bought this kit and love it. I have a shed and the height above the ground ended up being a lot higher than I thought(16-18 inches). I was going to use 2 2X12's for the stringers but obviously 12 inches is not high enough. I searched high and low and found that I could use this Brok solution. It's really easy to install. Just line up and mark the holes and dirll a 5/32 inch hole in a 2X12. After that hammer the screw through the board; then attach the kit to the board and tighten the bolts. I have 4 foot 2X12's and the diagram recommended I use a 5 1/2 foot ramp length. Still the 4ft boards worked fine. I also bought ramp ends from another seller but I really didn't even need to use this. I have a 28 inch Snapper riding mower that weights 300 lbs. I highly recommend this product.

These ramps were perfect for what I needed. Getting my job site table saw and mitersaw onto my trailer used to be a hassle and since I’m getting older, lifting them was becoming more of a challenge. With this ramp kit I just cut the 2x12s to the right length and bolted on the supports. It took me about 15 minutes. And those that reviewed and said the supports weren’t made for US dimensional lumber didn’t read the instructions. The lumber isn’t supposed to fit under the lip. Great product wish I had gotten them years ago.

Very east to set up. Took me 15 minutes. Ramps work great. Everyone complaining about the wood not fitting into the ramp groove clearly didn't bother to read the instructions. It isn't supposed to fit into it. Should be sitting flush, which is exactly what it does.

Item works very well, easy to assemble.