SM330 Thermal Pouch Laminator; Rigid Plastic Components and High-impact Plastic Body; 3 to 5 Minute Preheat Time; 3-position Switch for Heater and Enhanced Motor Drive

I use this laminator for toner transfer and I am very impressed with its performance. It does an amazing job in terms of consistency of the transfer to copper medium. Initially I thought it was a bit expensive compared to the alternatives that cost half as much but after seeing the results, I feel better for having spent more on this wonderful product. Its look and feel gives confidence on the quality of the build that will make it last for years.

Nice and rugged. Works great. It took a week or two to receive it from Ontario, but it was worth the wait.

Great product

This product functions well in my experience.

Excellent product! I would recommend this product to anyone.

I bought this laminator because it had been advertised to have the heat required for toner transfer in DIY PCB manufacturing, but even at maximum heat setting (with PLENTY of time to warm up) this laminator could not transfer even the tiniest amount of toner onto my (thoroughly cleaned and prepared) copper-clad board, I passed the board assembly through the laminator at least 30 times. In the end a $15 walmart clothes iron had to be used to finish the build.

The laminator jammed ALL the time! Now less than a year after we bought it, it is broken. It was way too hot then it wouldn't get hot enough to laminate 3 mil sheets. It was way too expensive a laminator to not even last a year.

Looks good, haven't tried it out. Quality great