LED Driver 150 Watts Waterproof IP67 Power Supply Transformer Adapter 85V-265V AC to 12V DC Low Voltage Output with 3-Prong Plug 3.3 Feet Cable for LED Light, Computer Project, Outdoor Light

I bought it because my son owns a business and the old outside light fixture was out so I switched it over to LEDs lights. It also saved him money on his electricity bill and looks much better more equal through the whole system. It seems to work very well.

Used for deck led lights. Worked great.

I use a couple of these within a junction box to power LED strips and some Christmas decorations we have made that make use of LED Strips. Have not fully tested power rating, but can say that I project about 340 Watts on a controlled section of LEDs, this includes driving the power for the controller, an amplifier signal splitter and multiple LED Strips. Note: I connect 2 of these in parallel to provide approximately 340 watts of total power. The unit is well built and hermetically sealed, so although I don't have it exposed to the elements, I have high confidence that these units would perform well.

Fit as expected, fixed the problem, easy fix for antique sign.

Once it works, it stays working. For some reason it kept tripping my GFCI though. Might have been my setup however. I took out the GFCI it worked great. Using it outside to run computer fans to keep my rabbits cool. It’s under cover but after a quick inspection before installation, it appears to be pretty well sealed. I just wish there were switches installed, but I added my own to the wiring.

This is a good quality, waterproof LED power supply. I’ve used several of these in exposed locations and they have performed well in rain, snow and heat. The dual output leads let you supply two zones without having to piggyback one to the other. I’ve also used these indoors because they are fan-less (fan failure seems to be a common failure in air cooled power supplies).

I bought this to power 12v LED strips with a maximum draw of 75 watts, thinking that the higher rating would give me better longevity. Though the device feels heavy and well-made, it died after almost exactly 1 year in service. It was in use for around 8 hours a day.

I used this for my store sign after getting new rextin green leds - I swapped the led and a week later the ballast went so I got this one - not sure if I should be using 100w 200w or 300w but I got 200w aand it’s been working great