Flame KingFlame King Refrigerant Recovery Cylinder Tank - Reusable - DOT Compliant - Y-Valve Liquid/Vapor - 30 LB Pound , Gray

I must say this was a great buy. It works perfectly for my budget refrigerant recovery. I did run a vacuum on the tank prior to use with no issues. I also have no leaks in my tank. Recovered about 2 pounds so far and its been sitting. Still has 2 pounds in it. Its easier to use than some other tanks.

Works grear. Be sure you put a vacuum on the tank before using. You can not fill a vehicle with this recovered freon until it is ran through a recycle process.

Excellent tank, works as expected. No problems, no leaks, well made. Great value!

Retired an older R410 AC unit and recovered the refrigerant into this tank. Valves worked fine. It's holding everything and all the seals look good (no leaks after a month and a half - which if it was going to leak it should have started to do so by now).

Purchased, purged the nitrogen and vacuumed it down. Closed valves and retested. Held vacuum. Used to recover R-22 from my heat pump for repairs. Did not lose any weight over two weeks. Was able to remove all but 4oz of refrigerant and recharge. Great value.

80% capacity would be a fill weight of 24lbs. The water fill weight is 26.1 lb, and at 80%, it would be 20.9lb. Far short of what's advertised, but it's a recovery tank, not a new FREON tank. Well built, DOT legal and a pressure relief valve that keeps the tank pressure well below its rating, you can't beat the price. 4 stars only because it is not truly a 30lb as advertised, but at 80% fill it would be a big, heavy tank to lug around.

These tanks are about half the price of what you would pay at suppliers of HVAC, and they work great.

This one came stamped. Aaac Service Heating and air in McDonough recommend this tank. It came sealed and works well.