Dirt Guard Chassis Cover (Short) for Arrrma 1/8 Outcast BLX 6S and 1/10 Kraton 4X4 4S

Fits the Typhon mega although it’s a little big, I made it fit by just wrapping the extra mesh up in a zip tie and letting the extra length go in the rear and not zip up fully. It works really well for keeping the mud dirt rocks and even snow/water out of the chassis, water will actually bead off the mesh. The pics are about a week of on and off muddy grass, wet dirt road and snow followed by an air hose bath. If I didn’t have the mesh guard the entire insides would look the same, but the mesh keeps em looking like new, very pleased just wish I could find one specifically made for the Typhon mega/3s.

I was hesitant at first cause it didn't seem like it was gonna fit my notorious 6s but after a few minor alterations an prep work it was installed. It actually works alot better than I expected and easier to work with.. I live in the hills an it's pure mud this time of the year, this item saves me nearly 30-40 min of cleanup time each and every run. Yet to have issues with heat but will address that as it happens. Highly recommended for those muddy/dusty areas

The media could not be loaded.  It fits the BIGROCK great

I have one for almost every quad it’s great protection. What most people put these things through you can’t have enough.A GREAT BUY !!

This is a great product. In my opinion. It Velcros on and off if I don't want to use it. Zips open from either side. 👍 Keeps a great deal of snow / dust out of my electronics. I have it mounted on my Redcat Kaiju same chassis length as the Traxxas Maxx. Its a lil big on my rig but fine by me.

High quality mesh used. A must have for Outcast/Notorious or Kraton/Talion with high sidewalls and no tower to tower brace.Returning to merchant will cost too much!To install without Velcro, I put holes thru the Velcro padding and secured it to the chassis using the side guard screws. A zipper on either side allow for easy chassis access. Overall, it's a good upgrade for an Arrma that's got no roll cage, front dirt guards.

The velcro simply will not hold up in the long term. If I do it again I'm also buying a cheap pop-rivet gun to fasten the thing to the plastic walls of the chassis.

Fits 1/8 arrma typhoon