HogueOverMolded Rubber Grip for Kimber Micro 9 (Ambi Safety) with Finger Grooves, Black - 39080

Fit perfect on Sig 380 & feels good! If you have small hands such as size 4-5 ring size, it may be too much

The pattern on the grip bites in to your hand comfortably but tightly. It’s not as wide as the original rubber grip that came with my Micro 9 ESV, which makes this one BETTER. The other one felt slightly weird in places as it was too thick in parts where your hand muscles have to flex. This one has that perfect thickness. Combine it with the extended mag and you have the most comfortable set up you will get on a Micro Kimber.

I've been a Houge fan for a long time. I have sasquatch sized hands and These make my micro 9 way easier and more comfortable to handle. These also make my EDC look way cooler.

I love this grip! With the Hogue base plate extension, the grip feels more like a full sized pistol.

Easy install. Significantly improved purchase on the micro 9 which for me, immediately improved accuracy! Fit's perfectly and while not as "pretty" as stock grips, turned my micro 9 into the tool it was intended to be.

Improvement over the factory flat panels. Small 9mm's can get a little "sporty" with the recoil. These grips seem to help. Be prepared to apply a little heat to separate the bushings from the grip screws. As with another of my Kimbers, it seems the red thread-locker used to insure you don't back out the bushing from the grip frame got into the threads between the bushing and the screw. I ended up backing out the entire bushing/screw assembly, heating the very end of the exposed threads and then backing the screw out of the bushing. Once separated, you can then re-apply thread locker to the bushing (be more careful than the factory), re-install the bushing, let the thread lock dry and then assemble the grips to the bushing and send the screws in. Be very careful when heating up the ends of the screw threads so you can undo from bushing: There is a rubber washer under the heads of each of the grip screws. Just apply the flame to the very end of the screw/bushing connection and just enough to loosen up the thread lock. A small vise to mount the bushing in is very helpful. If no vise, careful application of vise grips.

These grips fit perfectly and provide for a comfortable fit.

Makes the Kimber Micro 9 seat square in your hand. Changes the whole grip of the firearm for the better! Allows for a identical grip on the firearm everything you draw it.