معلومات عنا
دعم العملاء
احصل على التطبيق
قم بتوجيه الكاميرا لتنزيل التطبيق
حقوق الطبع والنشر © 2024 Desertcart Holdings Limited
🔧 Elevate Your Drive with Precision!
The V-Groove Drive Pulley features a 6" diameter and a 1" bore, designed for compatibility with 4L/A and 5L/B belts. Its robust steel construction ensures durability, while the precise offsets enhance operational efficiency.
L**Y
Fit my needs.
Replaced the motor in my old bobcat and the shaft on new one was smaller than the old one. This was a bit smaller in diameter then the old one but about all I could find for the right price. Has worked good so far, although just yesterday the set screws worked lose and and the key fell out. Was able to tighten them enough to get it back to the garage. When I get another key I will probably use some threadlocker on them. Maybe didn’t have them quite tight enough. Other than that, I have two of these on the shaft, one drives the hydraulic pump and this runs the clutches. Bought the other one at a local store and is a 4 inch diameter. Both look well made and sturdy. Price was good compared to other choices, and there weren’t too many other choices.
D**L
Awesome company 🥰
There was a problem with my shipment and Phoenix Mfg. jumped through hoops to get my part to me.The product is built tough and looks like it's going to last a very long time. I've had to use the pulley puller on it once and it never even acted like it was going to flex.I highly recommend this company and I'm going to look at them first when I'm ordering parts for the mowers I work on.
R**I
Satisfied
Good product, works as described.
A**R
Good fit
Little pricey but worked good except had an issue with the set screw stripping
M**S
Good quality.
Would order again.
M**N
Great pulley for mud and racing mower builds
great quality, never stripped out a key way. Also the groves on the pulley are deep, so i never had problems with the belt popping off of this pulley. if your running this on a ytp chassis then the clutch pulley will rub a a little bit when pushing the clutch all of the way down. to fix that just put a smaller pulley on the clutch and you will be fine.
R**T
Haven’t tested it yet
Got this for a pulley swap on my mower and I didn’t measure anything and it’s like a centimeter away from the idler when the brake is engaged 😂and hopefully those Allen bolts hold it cause I didn’t have a key way but it should be good but it ain’t got no gas in it right now so I can’t test it I should be pretty fast I got a 3 on the rear
P**R
Perfect fit
Quick service and great quality part
ترست بايلوت
منذ يوم واحد
منذ شهرين