FYSETC Ender 5 Plus Bed Columns, 4Pcs 3D Printer Ender 3 S1 Pro Solid Bed Mounts, Height 18mm 0.7inch OD 0.63inch Stable Heat-Resistant Buffer for Ender 5 Pro Ant A8 Wan-hao D9 Prus i3 Meg pro-Black

Installed these on my Ender 5 Plus. I was very pleased with the results. While I still check my bed level before every print, I notice that it's way more consistent, and far less adjustment is required when I manually level the bed, were talking fractions of a turn for every bed screw to get my paper to exhibit the right amount of drag. Since I have a BLTouch, I'm sure I could just probe the bed and it would print fine every time just off the auto leveling measurement.Furthermore, being stiffer than the stock springs, these columns have allowed me to really crank up my print speeds, so parts finish sooner with no loss in quality. These work best when paired with anti-backlash leadscrew nuts, which I also installed shortly after this upgrade. They are definitely worth the investment. I'm very impressed, and would recommend these on any machine, and they are practically a must if you have an auto-leveling probe on your machine.

For ender 5: if you use adjustable struts to support the cantilever bed you will likely have a tilt to the underlying structure that these sit on to support the bed. To solve this issue I carefully measured the height difference (2.2 mm in my case) and then designed And printed 2 spacers to place under the back positions. By doing this, I didn't have to over compress the front 2 silicone spacers to get to a level setting.Since installing these my bed is super steady and does not drift / shift at all. I can go weeks or more without touching my leveling knows. Well worth the money

Ordered for an Ender 3 Max (read: fixes zstop). Couldn't print a mod for it, bc the printer was in pieces out of adjustment. Had to shim the spacers up: 2 5/16" washers for where the bed cable comes in, 3 washers, same size, on other 3 corners, to bring the bed up above where the zstop ends.

I purchased these because I had upgraded to BL touch and I wanted to minimize any inconsistency from the springs. Install was easy but my support bed was pretty warped so I had to do a little bending to get it level before I could put these on. After that I did a quick manual bed leveling. These have a nice squish to them, so you can get a good level bed, but are firm enough so that the knobs won’t spin off or loosen over time. Glad I made the upgrade and worth the price! They also came in a nice quality plastic case which I used to store some other small parts I had laying out so, extra little bonus there.

What a difference these things made on my Mega Pro. Easy to install, level printer and your good to go.Buy these!

I use these on my Monoprice Maker Select and they have been a great replacement to the stock springs. They do an excellent job of holding position and have led to far fewer print failures since I've installed them. Granted, I still get print failures from time to time but that's my own fault almost always.

I had the readjust my Z home after getting these due to them being taller than the Springs that came with my Ender 3 however they work really well.

They say sometimes the smallest things can make the biggest difference and for these its true! I purchased these for my ender 5 plus and they are fantastic. I like them so much I’m buying a second set fur my Ender 5 pro. I will never use springs again on my machines. These are firm and make bed leveling a breeze compared to springs. Give these a try you won’t regret it

Fais bien la job